ICON Health & Fitness Pro-Form 750 RX User Manual page 12

HOW TO USE THE MANUAL MODE
Turn on the console.
1
Note: The console requires four 1.5V "D" batteries.
If you have not installed batteries, see assembly
step 5 on page 6.
To turn on the console, press the On/Reset button
or begin pedalling.
Select the manual mode.
2
Each time the
console is
turned on, the
manual mode
will be select-
ed. If a workout
program has
been selected,
select the manual mode by pressing the Program
button repeatedly until the upper right corner of
the display is blank.
Begin pedalling and adjust the resistance of
3
the elliptical crosstrainer.
As you pedal, adjust the resistance of the ellipti-
cal crosstrainer as desired by pressing the + and
– buttons. There are ten resistance levels; level
10 is the most challenging. Note: After the but-
tons are pressed, it will take a few seconds for the
selected setting to be reached.
Follow your progress with the feedback modes
4
and the left pace indicator.
When the con-
sole is turned
on, the scan
mode will be
selected. As
you pedal, the
display will
show your cur-
rent speed, the elapsed time, the distance that
you have pedalled, the current resistance level,
All manuals and user guides at all-guides.com
This corner
should be blank
12
and the approximate numbers of calories and of
fat calories you have burned (see FAT BURNING
on page 16). In addition, your heart rate will be
shown when you use the handgrip pulse sensor
or the optional chest pulse sensor. Note: Each
time the resistance level changes, the console
will show the resistance level for six seconds.
When a program is selected, the display will
show the time remaining in the program instead
of the elapsed time.
If desired, you can select a single feedback mode
for continuous display. Press the Display button
repeatedly until only the MPH (or Km/H), Time,
Miles (or Kms), Resist., Cals., or Fat Cals. indica-
tor appears in the display. Make sure that the
Scan indicator does not appear.
In addition, the left pace indicator will appear in the
display. As you increase or decrease your pace,
the indicator will increase or decrease in height.
Measure your heart rate if desired.
5
Note: If you wear the optional chest pulse
sensor and hold the handgrip pulse sensor at
the same time, the console may not display
your heart rate accurately.
Note: If there
are thin sheets
of plastic on
the metal con-
tacts on the
handgrip pulse
sensor, peel off
the plastic.
To use the handgrip pulse sensor, place your
hands on the metal contacts. Your palms must be
on the upper contacts and your fingers must be
touching the lower contacts. Avoid moving your
hands. When your pulse is detected, the heart-
shaped indicator in the display will flash each
time your heart beats. After a moment, two dash-
es (– –) will appear and then your heart rate will
be shown.
Metal
Contacts