Table of Contents
Advertisement
Quick Links
Installation & Operations Manual
Emergency Tower Phone
36" Emergency Call Station
• 2100-TPL Landline 120v Tower
• 2100-TPC Cellular 120v Tower
• 2100-TP9 900 MHz 120v Tower
• 2100-TPT 2-Way Radio 120v Tower
• 2100-TPV VoIP 120v Tower
• 2100-TPW Wi-Fi VoIP 120v Tower
N56W24720 N. Corporate Circle
Sussex, WI 53089
RP8500040
Made in the USA
Ver. 6
800-451-1460
www.rathcommunications.com
2 Year Warranty
10/17
Advertisement
Table of Contents
Related Manuals for Rath 2100-TP9
Summary of Contents for Rath 2100-TP9
- Page 1 Emergency Tower Phone 36” Emergency Call Station • 2100-TPL Landline 120v Tower • 2100-TPC Cellular 120v Tower • 2100-TP9 900 MHz 120v Tower • 2100-TPT 2-Way Radio 120v Tower • 2100-TPV VoIP 120v Tower • 2100-TPW Wi-Fi VoIP 120v Tower N56W24720 N.
-
Page 2: Table Of Contents
Thank you for purchasing RATH’s 120v Tower Phone. We are the largest Emergency Communication Manufacturer in North America and have been in business for over 35 years. We take great pride in our products, service, and support. Our Emergency Products are of the highest quality. -
Page 3: Description
Description Figure 1: Front & Back View Features: • ADA compliant (hands free operation) • LED call status indicator Panel 1 • Powder coated steel construction inside and out • Aluminum access panels powder coated inside and out • Weather and vandal resistant •... -
Page 4: Items Needed
2. Connect the electrical wires from the conduit to the wires in the Tower using the waterproof wire nuts located on the wires. Note: RATH® offers 120v, 277v, or 480v as power options. Power preference should be disclosed at point of sale and corresponding transformer will be installed in Tower. - Page 5 4. When the “PWR”, “RDY”, and “NW” lights on the front of the unit are illuminated, unit is ready. 5. Verify SmartPhone is plugged into the FXS port on Cellular Module. Note: If the SIM card is not provided to RATH® at time of purchase, an active SIM Card will need to be installed into SIM Card slot.
-
Page 6: Phone Programming
Phone Programming 1. You can program the phone on-site or remotely. Note: Cellular and 900 MHz applications cannot be remotely programmed. 2. If programming on-site, remove the face plate. Use the #10 spanner bit provided to remove the 6 security screws. 3. -
Page 7: Phone Testing
If you have answered YES to all questions, you have successfully installed and tested the phone. If you answer NO to any question, proceed to the Troubleshooting Section. *RATH® recommends the Tower be tested on a regular basis to ensure proper operation. Adjusting the Volume If the volume is too low or high, adjust it by referring to the diagram and instructions below. -
Page 8: Troubleshooting
Troubleshooting Problem Possible Cause & Solutions No dial tone when the • Check to make sure the phone line is connected to SmartPhone board. button is pushed: • Verify dial tone and voltage on phone line going into unit. Audio is low from the speaker: •... -
Page 9: Wiring
Wiring Strobe Strobe Constant Enter Record Play / Pause Stop LN G 120v Wago Connector to front plate Phone line to communication source Page 9...
Need help?
Do you have a question about the 2100-TP9 and is the answer not in the manual?
Questions and answers