Samsung RF23J9011 User Manual page 16

HOW TO ADJUST THE DOOR
HEIGHT
If any one of the doors is lower
than the other:
• Check if the Refrigerator is
level before adjusting the
door.
• Adjust the door height difference by inserting a
Snap Ring (1) as shown between the door and
the hinge.
You can install a ring on the right side door of
the fresh food compartment and both sides of
the freezer compartment.
• After checking the height difference, select one
Snap Ring with a suitable thickness. Insert that
one Snap Ring only. Inserting two or more Snap
Rings may cause the Snap Rings to slip out or
make a rubbing noise.
• Lift up the lower door and insert the Snap Ring
into the space between the Door and the Hinge.
CAUTION
• To avoid injury, insert or remove Snap Rings
carefully.
• Keep the Snap Rings out of the reach of
children and make sure that children do not
play with them or put them into their mouths.
• 1 mm, 1.5 mm, 2 mm, and 2.5 mm Snap
Rings come with the Refrigerator.
• If the Refrigerator is level before you load it with
food, the Refrigerator may become unbalanced
due to the weight of the food.
If this occurs, adjust the level again using the
same procedure.
• If you raise the door too far, it can rub against
the Top Cover.
DA68-03194D-00.indb 16
Snap Rings included with the refrigerator:
1 mm
HOW TO ADJUST THE DOOR GAP
If the gap between the left and right fridge
compartment doors is not even.
• You can adjust the gap by
turning the bolt at the top
right of the cold storage
compartment door.
• Do not turn the bolt too far.
You can break it.
(1)
1. With the doors closed, remove the 3 screws
holding the top cover using a Phillips
screwdriver, and then lift it off together with the
connected cables.
2. Turn the bolt with a 4 mm
hexagonal L-wrench to
adjust the gap.
3. Turn the bolt clockwise to (
gap. Turn the bolt counterclockwise (
narrow the gap.
English - 16
1.5 mm 2 mm 2.5 mm
) widen the
14. 12. 18.
) to
9:41