Yamaha YXZ10YEXH Owner's Manual page 196

2. Remove panel A. (See page 8-10.)
3. Remove the passenger seat cushion.
(See page 4-25.)
4. Using a charged 12-volt battery, connect
the positive lead of the jumper cable to
the positive terminal of the battery in the
YXZ1000R and the other end of the pos-
itive lead to the positive terminal of the
charged battery.
8
1. Jumper cable positive lead
5. Connect the negative lead of the jumper
cable to the negative terminal of the
charged battery and the other end of the
negative lead to an unpainted metal sur-
face of the passenger seat frame near the
center console in the YXZ1000R.
1. Jumper cable negative lead
1
6. Start the engine. (Refer to "Starting the
engine" on page 6-2.)
7. After the engine starts, disconnect the
negative lead of the jumper cable from
the seat frame and charged battery, and
then disconnect the positive lead of the
jumper cable from the charged battery
and the battery in the YXZ1000R.
8. Install the seat cushion and the panel.
8-60
1