1. Transmission oil filler cap
2. O-ring
3. Dipstick
4. Maximum level mark
5. Tip of the dipstick
TIP
The transmission oil level should be between
the tip of the dipstick and the maximum level
mark.
4. If the oil level is at or below the tip of the
dipstick, add sufficient oil of the recom-
mended type to raise it to the correct lev-
el.
2
3
1
4
5
5. Check the O-ring for damage, and re-
place it if necessary.
6. Install the transmission oil filler cap.
7. Install the panel.
To change the transmission oil
1. Park the vehicle on a level surface.
2. Remove panel B (page 8-10).
3. Place an oil pan under the transmission
case to collect the used oil.
4. Remove the transmission oil filler cap,
and then the transmission oil drain bolt
and its gasket to drain the oil from the
transmission case.
8-27
8