Shure MXW6W Manual page 37

Software Introduction
Preferences Tab
① Switch Behavior
Customize the switch for each microphone type.
• Toggle: Press and release the button to change the status to Active
or Mute.
• Push-to-talk: Hold button to pass audio.
• Push-to-mute: Hold button to mute the audio.
• Disabled: The button does not affect the audio.
② Initial State from Charger
Assigns the initial state for each microphone type after removal from the
charger:
• Active: Microphone is on and passing audio to the network.
• Mute: Microphone is on but the signal is muted.
• Standby: Conserves battery charge and allows the GUI to change the
state to Active or Mute.
• Off (Inactive): The microphone is powered off. A microphone in this
state cannot be controlled by the GUI (it can only be turned on using
the power button on the mic).
③ LED Behavior
Set the behavior of the mute/active LED for each microphone type:
Mute Active
Solid Solid
Red Green
Flashing Solid
Red Red
Solid
Off
Red
Solid
Off
Red
Flashing Solid
Green Green
Standby mode is always represented with a pulsing red LED.
④ Mute Preference
• Local Mute - Individual: Each microphone is muted individually.
• Local Mute - All: All microphones mute when any microphone is muted.
• External Mute: Microphones are muted by a 3rd-party control device.
⑤ RF Power Max
Determines the maximum distance that an APT will transmit.
• Low: ??'
• Medium: ??'
• Medium High: ??'
• High: ??'
⑥ Out of Range Alarm
⑦ Back in Range Action
⑧ Linking Preference
⑨ Language
⑩ Save/Load Preferences
⑪ Password Setup
⑫ Register the Product Link
32
Configuration Tab
① Device List
Customize the switch for each microphone type.
② Device Name
Device names can be customized with up to 31 any characters in length
except '=','.' or '@'.
③ Network Interface Selection
Determines which network interface's IP settings are displayed.
• Control:
• Network Audio:
④ IP Mode
Sets IP mode of the selected network interface:
• Auto (DHCP): For automatic DHCP or Link-Local IP addresses.
• Manual (Static): For Static IP addresses.
⑤ IP Settings
Displays the IP Address, Subnet Mask, and Gateway for each network
interface.
⑥ MAC Address
The network interface's unique identification.
⑦ Group Row
Assign APTs, chargers, and audio output devices to form each group.
⑧ id? Button
Commands the selected device's LEDs to flash for easy identification.
⑨ Link Button
Links microphones to channels for the selected charger.
Utility Tab
① Export
Exports the data table to a text file that can be saved to a computer.
② Group
Indicates to which group the device is assigned/linked.
③ Device
The device type or microphone channel.
④ Type
The device model number.
⑤ Name
Displays name as defined in ______??
⑥ IP Address Control
Displays the IP Address of the control network interface (Shure GUI
control).
⑦ IP Address Network Audio
Displays the IP Address of the Network Audio network interface (Dante
audio and control).
⑧ S/N
Displays the device's serial number.
⑨ % Battery Capacity
Percentage of charge capacity compared to a new battery.
⑩ Cycle Count
Number of charge cycles logged by the battery.
⑪ Current Version
Displays the device's firmware version.