Table of Contents
Advertisement
4. Press the left edge of the power button to release the power button a little bit. Then, remove the power
button from the front bezel as shown.
Figure 106. Removing the power button
5. Align the right edge of the power button with the hole in the front audio and USB assembly. Then, pivot
the power button inward as shown until it snaps into position.
Figure 107. Installing the power button
6. Connect the power button cable to the front-bezel connector on the system board. See "Parts on the
system board" on page 38.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 183.
146
P330 Hardware Maintenance Manual
Advertisement
Table of Contents
