Table of Contents
Advertisement
information, see instructions on
memory-and-storage/intel-optane-memory.html
An M.2 solid-state drive can be installed on the system board or an M.2 solid-state drive PCIe adapter.
M.2 solid-state drive on the system board
To remove or install an M.2 solid-state drive on the system board, do the following:
1. Prepare your computer. See "Preparing your computer" on page 96.
2. Locate the M.2 solid-state drive slot. See "Parts on the system board" on page 38.
3. Untie the cables that prevent your access to the M.2 solid-state drive slot from the cable clip.
4. To remove an M.2 solid-state drive, do the following:
a. Turn the two mounting studs 90-degree counterclockwise to release the heat sink. Then, lift the heat
sink off the plastic holder.
Figure 27. Removing the heat sink from the plastic holder
104
P330 Hardware Maintenance Manual
https://www.intel.com/content/www/us/en/support/articles/000023989/
.
Advertisement
Table of Contents
