Nortek Control Mighty Mule MM571W Installation Manual page 58

Replacement Transformer (RP1010)
19V, 2A, DC transformer for maintaining the battery with the Mighty Mule gate operator.
Push Button Control (FM132)
Unlit doorbell button for remote entry or exit control. Wires directly to the control board and uses 16-22 gauge stranded,
dual conductor low voltage wire (sold separately).
Low Voltage Wire (RB509-50 = 50' / RB509-100 = 100' / RB509-250 = 250' / RB509-500 = 500')
The 16 gauge, stranded, dual conductor Low Voltage Wire is for connecting the AC powered transformer, or the Solar
Panel to the control board. Also used for the connection of accessories, such as locks, keypads, push buttons and other
wired control devices. This specially designed wire is UV treated, PVC coated and ready for direct burial. Available in
1000' rolls or special lengths.
Wireless Entry Intercom / Keypad (MM136)
Allows owner to screen guest at the gate before allowing access to the property. Keypad also allows owner to give up to
25 programmable entry codes to family, friends or approved delivery personnel. Codes can be permanent or temporary.
Up to 500 feet reception.
Additional base stations available, up to four total. (MM136B)
Garage Door Receiver (RB709U-NB)
The Garage Door Receiver allows you to use the same Mighty Mule entry transmitter to operate your gate operator and
your garage door operator. Compatible with most garage door operators (not compatible with the MMK200).
Driveway Alarm (FM231)
This device alerts you of vehicles entering your driveway (with or without an automated gate). The indoor base station
signals you with a door chime when a vehicle passes the driveway sensor.
Key Chain Two Button Transmitter (FM134)
The Key Chain Transmitter is a dual button version of the Mighty Mule single button entry transmitter and has the same
adjustable code settings. Used for 2 gates or 1 gate and garage door (when used with in conjunction with a garage door
receiver – RB709U-NB). (Battery is included).
Single Button Transmitter (FM135)
The Mighty Mule entry transmitter, with adjustable code settings, is standard equipment with all Mighty Mule systems.
(Battery is included.)
If you have a question about any special order item, call Customer Service: 1-800-543-4283
The contents of all material available on this installation manual are copyrighted by Nortek Security & Control, LLC ("Nortek Security & Control"), unless otherwise indicated. All rights
are reserved by Nortek Security & Control, and content may not be reproduced, downloaded, disseminated, published, or transferred in any form or by any means, except with the
prior, written permission of Nortek Security & Control. Any reprinting of Nortek Security & Control publications is by permission only. Copyright infringement is a violation of federal law.
Mighty Mule¨, E-Z Gate¨, Nortek Security & Control¨, "Dual Sense Technology" are registered trademarks of Nortek Security & Control, LLC, America's DIY Automatic Gate Openers is a
trademark of Nortek Security & Control, LLC and are the exclusive property of Nortek Security & Control, LLC ("Nortek Security & Control").
All rights are reserved by Nortek Security & Control, and these marks may not be used, in any for without the prior, written permission of Nortek Security & Control.
MM571W / MM572W Installation Instructions
55