Tools Needed; Items Not Included; Check Direction Of Gate Swing - Nortek Control Mighty Mule MM571W Installation Manual

Drill
Level
Clamps
● Low voltage wire will be needed to run from the
transformer to the control box; length depends
upon the distance between the transformer power
supply and the control box. You will need 16 gauge,
low voltage direct burial wire. See Transformer/
Solar Panel Wiring Installation on page 38 and the
accessory catalog.
● PVC conduit.
● If you have thin-walled tube or panel gates, see
Reinforcing Gates for the Gate Brackets, next page.
● Depending on the type of gate, a horizontal cross
member or mounting plate may be needed to
mount the front of the operator and gate bracket to
the gate. See the Reinforcing Gates for the Gate
Brackets examples, next page.
Instructions begin on page 2.

TOOLS NEEDED

7/16" Bit
1/2" Bit
7/32" Bit
Pliers
Hack Saw
wrench

ITEMS NOT INCLUDED

CHECK DIRECTION OF GATE SWING

Your Property
Pull-to-Open Option
Pull-To-Open
(arm retracts to open)
Pen
Philips Head
Screwdriver
9/16"
Adjustable
Wrench
● Surge protection for transformer.
● Some types of installations require u-bolts.
● Additional washers or a metal plate may be
needed for wooden post.
● Weatherproof cover for outdoor outlet and
transformer.
● If the post is larger than 6", bolts longer than 8"
are needed.
(Requires Push-To-Open Bracket
#FM148—NOT INCLUDED)
Your Property
Push-to-Open Option
Push-To-Open
(arm extends to open)
Instructions begin on page 8.
14
Center
Punch
1/2"
wrench
Flat Head
Screwdriver
Wire
Small
Stripper
Flat Head
MM571W / MM572W Installation Instructions
Hammer
Tape
Measure