System Board - HP Compaq 2533t Maintenance And Service Manual

System board

Description
System board (includes processor, replacement thermal material, and replacement thermal
material cleaning kit)
Before removing the system board, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Flash drive (see
b. WLAN module (see
c. Optical drive (see
d. Switch cover and keyboard (see
e. Display assembly (see
f. Top cover (see
When replacing the system board, be sure that the following components are removed from the defective
system board and installed on the replacement system board:
●
Memory module (see
●
Flash drive (see
●
Heat sink (see
●
WLAN module (see
Remove the system board:
1. Release the ZIF connector to which the front LED board cable is attached and disconnect the front
LED board cable (1) from the system board.
2. Disconnect the speaker cable (2) from the system board.
Battery on page
Flash drive on page
WLAN module on page
Optical drive on page
Display assembly on page
Top cover on page
Memory module on page
Flash drive on page 36)
Heat sink on page 63)
WLAN module on page
30).
36)
34)
38)
Switch cover and keyboard on page
47)
52)
32)
34)
Component replacement procedures
Spare part number
481091-001
40)
57