Toshiba MCY-MHP1006HS8-E Owner's Manual page 17

2FAN_OM_DB04307201-04_EN.book Page 16 Tuesday, December 17, 2019 6:33 PM
Cyclic swing (Recommended for cooling)
All four louvers swing at different times like waves.
(2)
(3)
(1)
(4)
(2)
(4)
(1)
(3)
(1)
(2)
(4)
(3)
(2)
(1)
(3)
(4)
EN-31
Setting the louver lock
1
Push and hold the UNIT LOUVER button (right side of
the button) for at least 4 seconds while running
is stopped.
blinks.
• When no unit number is displayed, all units are
selected.
2
Push the UNIT LOUVER button (left side of the button)
to select a unit.
The unit number changes each time you push the
button.
Unit No. Unit No. Unit No.
1-1 1-2 1-3
Unit No.
1-4
The fan of the selected unit runs, and the louver
swings.
3
Push the "TEMP. " buttons to display the
number of the louver to fix its direction.
The selected louver swings.
4
Push the TIME buttons to select the
direction of the louver you do not want to swing.
(1) (2) (3)
0001 0002 0003
(4) (5)
0004 0005
* If (4) or (5) is selected, condensation may occur
during cooling.
5
Push the button to confirm the setting.
When the setting is confirmed, the mark lights up.
(To set the louver lock of another unit, repeat from
Step 2. To set another louver lock of the same unit,
repeat from Step 3.)
– 16 –
6
Push the button to finish the setting.
0001 - 0005
(Louver position
Louver No.
code)
* F1 appears in the CODE No. section on the
remote controller. This indicates that the louver 01
shown in the following figure is selected.
Electrical control box
Refrigerant
pipe
Drain pipe
NOTE
Even in louver lock mode, the louver temporarily moves
in the following cases:
• When the air conditioner is stopped
• When heating starts
• When defrosting
• When thermo. off.
Releasing the louver lock
Set "0000" in Step 4 of "Setting the louver lock".
The mark disappears.
* Steps 1 - 3 and 5, 6 of "Setting
SET DATA
the louver lock" also apply to
0000
releasing the lock.
Owner's Manual
Adjusting the horizontal direction
1
Push and hold the and "TEMP. "
buttons for at least 4 seconds while running is
stopped.
blinks.
"01" appears in CODE No.
2
Push the UNIT LOUVER button (left side of the button)
to select a unit.
The unit number changes each time you push the
button.
Unit No. Unit No. Unit No.
1-1 1-2 1-3
No Unit No.
display 1-4
The fan of the selected unit runs, and the louver
swings.
3
Push the "TEMP. " buttons to change
the CODE No. to "45".
4
Push the "TIME "buttons to select a
direction.
Direction SET
Direction setting
DATA
Smudging reduction position
"0000" (reduces ceiling smudging)
(factory default)
Cold draft position
"0002" (Less directly expose your body to
cool air)
5
Push the button to check the settings.
The indicator stops blinking and stays lit, and the
settings are confirmed.
6
Push the button to finish the setting.
* If the cold draft position is selected, the ceiling
smudging reduction effect will be reduced.
EN-32