Lexus UX 250h 2020 Owner's Manual page 318

316
5-6. Using the other interior features
garage door opener motor will
blink twice, indicating that 2-way
communication is enabled.
If the indicators do not flash, perform
3
within the first 10 presses of the
®
HomeLink button after programming
has been completed.
2
Press a programmed HomeLink
button to operate a garage door.
3
Within 1 minute of pressing the
®
HomeLink button, after the
garage door operation has
stopped, press the "Learn" or
"Smart" button on the garage door
opener motor. Within 5 seconds of
the establishment of 2-way com-
munication with the garage door
opener, both garage door opera-
tion indicators in the vehicle will
flash rapidly (green) and the light
on the garage door opener motor
will blink twice, indicating that 2-
way communication is enabled.
Reprogramming a single
■
®
HomeLink button
When the following procedure is per-
formed, buttons which already have
devices registered to them can be
overwritten:
1
With one hand, press and hold the
desired HomeLink
2
When the HomeLink
starts flashing (orange), continue to
hold the HomeLink
perform "Programming
®
HomeLink "
2
and
®
button.
®
indicator
®
button and
1
(it takes 20 seconds
for the HomeLink
start flashing).
Before programming
■
● Install a new battery in the transmitter.
The battery side of the transmitter must
●
be pointed away from the HomeLink
®
Operating HomeLink
Press the appropriate HomeLink
button. The HomeLink
should turn on.
The status of the opening and closing
of a garage door is shown by the indi-
cators.
Opening
A
Closing
B
This function is only available if the garage
door opener motor used is a compatible
device. (To check device compatibility,
refer to www.homelink.com.)
Color
Orange (flashing)
Green
Red (flashing)
®
indicator to
®
.
®
®
®
indicator light
Status
Currently open-
ing/closing
Opening/closing
has completed
Feedback signals
cannot be received