Cisco Aironet 1520 Series Hardware Installation Manual page 44

Installation Guidelines
R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
Figure 2-5
Figure 2-5
Adding the Access Point MAC Addresses to the Controller Filter List
Before installing your access points, configure your controller by adding the MAC addresses of the
access points to the filter list. MAC address filtering is enabled by default. This enables the controller
to respond to the listed access points. Follow these steps to add a MAC filter entry on the controller:
Log into your controller using a web browser.
Step 1
Choose SECURITY > MAC Filtering > New.
Step 2
Enter the MAC address of the access point to the MAC Filter list; for example, 00:0B:91:21:3A:C7.
Step 3
Note
Cisco Aironet 1520 Series Outdoor Mesh Access Point Hardware Installation Guide
2-14
shows the antenna port locations viewed from the hinged cover side.
Antenna Port Locations
The access point MAC address is located on the bottom of the unit. When two MAC addresses
are shown, use the top MAC address.
Chapter 2 Mounting Instructions
OL-12632-03