Attaching The Hood; Attaching The Anti-Reflective Film - JVC GY-HM180U Instructions Manual

Estimated Charging and Continuous
Operating Times
o Charging time
SSL-JVC50 (accessory) n : Approx. 4 hrs
BN-VC826 (accessory) m
M
* When the [POWER ON/OFF] switch is set to "OFF"
Memo :
If you charge the battery immediately after using while
0
the battery is still warm, it may not be fully charged.
o m M
It is recommended that you charge the battery in an
0
environment between 10 °C and 30 °C (50 °F and
86 °F). The battery may not be fully charged or the
charging time may be prolonged if charged under low
temperatures (below 10 °C/50 °F). In addition,
charging the battery under high temperature (above
30 °C/86 °F) condition may shorten the battery life.
o n
For details, refer to the "INSTRUCTIONS" of the
0
battery.
o Continuous operating time
SSL-JVC50 (accessory)
n
BN-VC826 (accessory)
m M
*1 When [System] is set to "4K" and all other
settings are in factory default
*2 When [System] is set to "HD" and all other
settings are in factory default
Memo :
Actual operating times may differ depending on the
0
age of the battery, charging condition, and operating
environment.
Operating time is shortened in cold environment.
0
The operating time may shorten when power zoom is
0
used, accessories are connected, or when the LCD
monitor is frequently used.
For purchase of spare batteries, please contact the
0
local dealers in your area.
16
Charging the Battery
: Approx. 3 hrs 40
mins
: Approx. 4 hrs (*1)
Approx. 4 hrs 30 mins
(*2)
: Approx. 1 hrs 55 mins
(*1)
Approx. 2 hrs 15 mins
(*2)

Attaching the Hood

Attaching the Hood
Align the markings on the camera recorder and
hood; turn the hood in the direction of the arrow
(clockwise) until it is locked.
.
Attaching the Anti-
reflective Film
Attach the supplied anti-reflective film onto the LCD
monitor if necessary, such as when you are
recording in the day or outdoors.
Doing so helps to cut down reflection of outside
light, thus improving the visibility.
1 Wipe off any dirt, dust or stains on the
surface of the LCD monitor.
2 Peel off the backing of the anti-reflective
film halfway.
Pay attention to prevent fingerprints from being
left on the adhesive face.

3 Attaching the Anti-reflective Film

Align and paste the anti-reflection film on the
0
LCD monitor screen without trapping any air
bubbles.
Squeeze the air bubbles out.
0
You may repaste the anti-reflection film if air
0
bubbles are accidentally trapped.
Memo :
Do not press the LCD monitor surface with
0
excessive force when attaching the film.
For additional orders of the anti-reflective film,
0
please consult the authorized dealer from which
this camera recorder was purchased, or our
service center.