Table of Contents
Advertisement
English
EMC declaration
This product is developed in accordance with the European standards
EN 55014 and EN 50082-1, tested corresponding to the EC - directive
89/336/EWG (EMVG of 09/11/1992, electromagnetic tolerance) and
meets legal requirements.
To guarantee the electromagnetic tolerance you must take the
following precautions:
§
Connect the transformer only to an approved mains socket installed
by an authorised electrician.
§
Make no changes to the original parts and accurately follow the
instructions, print layout and circuit diagram included with this
manual.
§
Use only original spare parts if you have to repair the module.
Operation overview
The decoder is designed for operation in Motorola II format and can be
adjusted to one of 255 addresses. It evaluates the digital data sent by the
central unit to its address. It controls the locomotive's motor and the
driving characteristics. In addition, it switches four function outputs,
which can for instance be used for the locomotive's lighting.
In Motorola I format it is possible to operate the decoder, but the
programming of the parameters and the controlling of the functions is
restricted.
Automatic recognition of the analogue mode
The decoder can also be used in analogue model railway layouts run with
an A.C. speed control. When putting the locomotive on the rails the
decoder recognizes automatically if it is run in analogue or digital mode
and sets the corresponding operation mode. The automatic recognition of
the analogue mode can be switched off by programming the decoder
accordingly.
Page 34
LD-G-14
Advertisement
Table of Contents
