Operation - tams elektronik LD-G-14 Manual

English
Switch on and off
"function" (f0) once
Push "Stop"

Operation

Acceleration and brake delay
In Motorola II format the acceleration and brake delay is switched
alternately on or off by switching on the function F3. F3 "off": delay
active. The change of the setting takes effect immediately. If the
acceleration and brake delay is switched off during braking the
locomotive immediately runs with the speed level set at the central unit.
In Motorola I format the acceleration and brake delay is always active.
An emergency stop during acceleration and brake delay can be
performed from the central unit by changing the direction of travel.
Switching the shunting gear
In Motorola II format the shunting gear can be switched on and off via
the auxiliary function F4. In Motorola I format the shunting gear cannot
be activated.
Improvement of the driving characteristics
Locomotives with especially high current consumption or track sections
with bad contacts (e.g. some types of points) may give an
unsatisfactory performance after the mounting of the locomotive
decoder. You can improve the locomotive performance by soldering a
capacitor 100 µF / > 35 V to the points X8 and X15 (see fig. 1 and 3).
Page 52
Turn the speed control knob until the
locomotive drives with the desired maximum
velocity.
The settings are saved and the locomotive´s
lighting flashes intermittently. The decoder
changes to the setting of the starting
velocity (the locomotive runs slower).
The programming mode is finished.
LD-G-14