Cleaning And Servicing - Bosch CreationLine MUM59N26 Instruction Manual

en Cleaning and servicing
Warning!
Prevent the cut ingredients from building up
in the outlet opening.
Tip: To ensure even cutting results, process
thin ingredients in bunches.
Note: If the food to be processed sticks in
the continuous­feed shredder, switch food
processor off, pull out mains plug, wait until
the drive comes to a standstill, remove
cover from the continuous­feed shredder
and empty feed tube.
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Rotate the continuous­feed shredder in
an anti­clockwise direction and remove.
■ Rotate the lid in an anti­clockwise direc­
tion and remove.
■ Remove disc holder with disc. To do this,
press finger from below against the drive
shaft (Fig. H).
■ Clean parts.
Blender
W Risk of injury from sharp blades /
rotating drive!
Never place fingers in the attached blender!
Do not remove / attach the blender until the
drive is at a standstill! Operate the assem­
bled blender only and with the lid attached.
W Risk of scalding!
If processing hot liquids, steam escapes
through the funnel in the lid. Add a
max. 0,5 litres of hot or frothing liquid.
Warning!
Blender may be damaged. Do not process
deep­frozen ingredients (except ice cubes).
Do not operate blender when empty.
Working with the blender
Fig. J:
■ Press the release button and
move the swivel arm to
position 4.
■ Remove the blender drive cover.
■ Attach blender jug (mark on the handle
on mark on the base unit) and turn all the
way in an anti­clockwise direction.
24
■ Add ingredients.
Maximum amount of liquid = 1.25 litres;
maximum amount of frothing or hot
liquids = 0.5 litres;
Optimal processing capacity –
solids = 50­100 g;
■ Attach the cover and turn anti­clockwise
all the way into the blender handle. The
cover must be locked in position.
■ Set the rotary switch to the desired
setting.
Adding more ingredients
Fig. J-8:
■ Switch off the appliance with the rotary
switch.
■ Remove the lid and add ingredients
or
■ remove the funnel and gradually add solid
ingredients through the refill opening
or
■ pour liquid ingredients through the funnel.
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Rotate the blender in a clockwise direc­
tion and remove.
Tip: It is recommended to clean the blender
immediately after use.

Cleaning and servicing

Attention!
Do not use abrasive cleaning agents. Sur­
faces may be damaged.
Cleaning the base unit
W Danger of electric shock!
Never immerse the base unit in water or
place under running water. Do not use a
steam cleaner.
■ Remove mains plug.
■ Wipe the base unit and drive cover with
a damp cloth. If required, use a little
detergent.
■ Then dry the base unit.