Disassembly Procedure - Mitsubishi Electric Mr.Slim PUZ-A18NHA4R1 Service Manual

15

DISASSEMBLY PROCEDURE

PUZ-A18NHA4
PUZ-A18NHA4R1 PUZ-A18NHA4R1-BS
OPERATING PROCEDURE
1. Removing the top panel, service panel, front panel and
back panel
(1) Remove the top panel fixing screws (4 × 10), one from the
right and two from the left side, and detach the top panel.
(2) Remove 1 service panel fixing screw (4 × 10) and detach
the service panel by pulling it downward. (See Photo 1)
(3) Remove the front panel fixing screws (4 × 10), 5 from the
front, 2 from the right and 2 from the left side, and detach
the front panel.
(4) Remove the conduit cover and cord cover fixing screw (2
pcs. 4 × 10), and detach the conduit cover and cord cover.
(See Photo 2)
(5) Remove the back panel fixing screws (4 × 10), 4 from the
right and 3 from the rear side, and detach the back panel.
2. Removing the fan motor
(1) Remove the top panel. (See Photo 1)
(2) Remove the front panel. (See Photo 1)
(3) Remove 1 nut (M6, left-screw) and detach the propeller.
(4) Disconnect the connector CNF1 on the controller circuit
board in the electrical parts box.
(5) Loosen the clamp for the lead wire in the motor support.
(6) Remove 4 fan motor fixing screws (4 × 18) and detach the
fan motor. (See Photo 3)
OCH481C
PUZ-A18NHA4-BS PUY-A12/18NHA4
PUY-A12/18NHA4R1
Photo 1
Grille
Front panel
Photo 2
Photo 3
Nut
Photo 4
Fan motor fixing screws
Fan motor
(MF1)
Fan motor fixing screws
106
PUY-A12/18NHA4-BS
PUY-A12/18NHA4R1-BS
PHOTOS
Top panel
Top panel
fixing screw
Service panel
for charge plug
Service panel
Cord cover
Conduit cover
and cord cover
fixing screws
Conduit cover
Propeller Electrical parts box
Clamp
Motor support