Advertisement
B. Place microscope directly in front of you in a manner which permits you to comfortably look into the
eyepiece. Note that the head of the microscope rotates 360°, permitting you to operate the
microscope from the front or the back, whichever is most convenient. Most users will position the
microscope with the arm facing you so that focusing knobs are most convenient to reach.
C. First, assure that light is available for illuminating the specimen.
1. Make certain that the main voltage of your microscope corresponds to the voltage of your power
outlet, 120V AC. Insert plug into matching voltage output.
2. Flip switch located on base to ON position.
3. In case of equipment malfunction, see Troubleshooting procedures located at the back of this
manual.
D. Rotate focus knobs to move stage down (away) from objectives as far as possible.
E. Place specimen slide, cover slip facing up, on stage with specimen centered over lens in middle of
stage.
F. Rotate disc diaphragm to position the largest aperture under the hole in center of stage.
G. Turn the objective turret until the 4x (smallest) objective lens clicks into position in the optical path.
Note that each time you change from one objective lens to another you should turn the turret until you
hear the click, which indicates that the lens is properly indexed in the optical path.
H. While looking through the eyepiece, rotate focusing knobs until specimen comes into focus. If image
does not appear in field of view, move specimen slide slightly on stage until image appears in field of
view.
I.
Turn the disc diaphragm, observing that different apertures affect the sharpness of the image. Turn
diaphragm until sharpest possible image is obtained. When turning the disc diaphragm, you should
hear a click as each aperture comes into proper position under the hole in center of stage. If aperture
is not properly positioned, you will observe shadows in the field of view when looking through the
microscope.
J. Changing magnification
1. Note that each of the three objectives has a different color ring. This permits the teacher to
instruct the class to switch magnifications by referring to the color of the ring.
2. Total magnification obtained with each objective lens is determined by multiplying the
magnification of the eyepiece times the magnification of the objective. Keep in mind that as
magnification is increased, field of view (area of the specimen seen when looking through the
microscope) decreases. You will find that you use the lower magnifications at most times.
Always use the lowest magnification (4x objective) when first focusing on a new specimen slide,
as this low magnification provides the biggest field of view, thereby making it easier to find and
position the specimen within the field of view.
4x objective – "Red" color ring
10x objective – "Yellow" color ring
40x objective – "Blue" color ring
10x eyepiece x 4x objective = 40 times magnification. (biggest field of view)
10x eyepiece x 10x objective = 100 times magnification. (smaller field of view)
10x eyepiece x 40x objective = 400 times magnification (smallest field of view)
4
Advertisement
