Kenwood DNX7190DABS Instruction Manual page 98

Connection/Installation
Ñ
3-way speaker system setup
● Except DNX419DABS
Subwoofer Preout
Mid Range Preout
Tweeter Preout
When connecting to an external amplifier,
connect its ground wire to the car's chassis to
avoid damaging the unit.
Preout
RCA Cable
(Sold separately)
Power amplifier
(optional
accessory)
Input
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
NOTE
• For speaker system setup, see 3-way speaker
system setup (P.81).
• For speaker setup and crossover setup, see
Speaker / X'over setup (P.82).
• For how to connect speaker wires to terminals
other than speaker terminals and Preout
terminals, see Connecting the system and
external components (P.99) and Connecting
wires to terminals (P.97).
98
Speaker
+
To mid range left
speaker
+
To mid range right
speaker
+
To tweeter left speaker
+
To tweeter right
speaker
Speaker impedance: 4-8 Ω
Ñ
Wiring harness (Accessory 1)
connector function guide
Pin Color and function
A-4 Yellow
A-5 Blue/White
[2]
A-6 Orange/White Dimmer
A-7 Red
A-8 Black
B-1/B-2 Purple (+) / Purple/Black (–) Rear Right
B-3/B-4 Gray (+) / Gray/Black (–)
B-5/B-6 White (+) / White/Black (–)
B-7/B-8 Green (+) / Green/Black (–)
*Speaker Impedance: 4-8 Ω
[1] [2]: Blue/White wire is provided two wires, [1] and [2].
Blue/White wire total output ([1] + [2]):
12 V = 350 mA
#WARNING for Connecting the ISO
Connector
The pin arrangement for the ISO connectors depends
on the type of vehicle you drive. Make sure to make
the proper connections to prevent damage to the
unit. The default connection for the wiring harness is
described in (1) below. If the ISO connector pins are set
as described in (2), make the connection as illustrated.
Please be sure to reconnect the cable as shown (2)
below to install this unit to the Volkswagen vehicles etc.
(1): Default setting
The red (A-7 pin) of the vehicle's ISO connector is linked
with the ignition, and the yellow (A-4 pin) is connected
to the constant power supply.
Red (Ignition cable)
Unit
Yellow (Battery cable)
(2)
The red (A-7 pin) of the vehicle's ISO connector is
connected to the constant power supply, and the
yellow (A-4 pin) is linked to the ignition.
Red (Ignition cable)
Unit
Yellow (Battery cable)
Battery
Power Control
Ignition (ACC)
Earth (Ground) Connection
Front Right
Front Left
Rear Left
Red (A-7 pin)
Vehicle
Yellow (A-4 pin)
Red (A-7 pin)
Vehicle
Yellow (A-4 pin)