Installing The Wall Bracket - Becker Centronic EasyControl EC411 Assembly And Operating Instructions Manual

2) Programming additional transmitters
1. Press the programming button of the master transmitter until the re-
ceiver confirms.
2. Then press the programming button of the new transmitter until the re-
ceiver confirms.
3. Now press the programming button of the new transmitter again.
4. The receiver confirms successful programming.
The maximum transmitter range on and in the building is up to 10 m and in the
open up to 100 m.

Installing the wall bracket

Caution
If mounted in a switch box, the latter must be empty.
Prior to installation, the power supply must be disconnected.
The applicable regulations for electrical installation must be
complied with.
58,9
•
Before installation in the desired
installation position, check that
the transmitter and receiver are
functioning properly.
•
Fix the bracket to the wall with the
two screws enclosed.
15 - en