Smeg KV90XE Instruction Booklet page 7

2-DIGIT 10-KEY CAPACITIVE PUSHBUTTON BOARD:
Key Function
A Turns the suction motor on / off.
B Decreases the operation speed.
C Increases the operation speed.
Activates the Intensive speed from any speed even with the
motor off, this speed is timed. At the end, the system returns to
the speed previously set. Suitable for dealing with the maximum
D
emissions of cooking fumes.
Hold the button down for about 5 seconds, when all loads are off
(Motor + Light), to switch the keyboard lock On / Off.
24 H function
Activates the motor at the first speed and allows extraction for
10 minutes every hour.
E
Holding the button down for about 5 seconds when all loads are
off (Motor + Light), holding key "B" down during the animation,
the Active Carbon Filters Alarm switches On / Off.
Delay function
Enables the automatic shutdown delay of 30'. Suitable for
F
removing residual odours. Can be activated from any position.
You disable it by pressing the key or turning the motor off.
With the filter alarm in progress, pressing the key for about 3
G
seconds resets the alarm.
Decreases the light intensity at each press of the Key in a cyclic
H
manner.
1 Turns the lighting system on and off at maximum intensity.
Increases the light intensity at each press of the Key in a cyclic
L
manner.
Keyboard lock command: you can lock the keyboard, for example, to clean the glass
surface, when the Hood has the motor and lights switched off. By pressing key D
for about 5 seconds, you can enable or disable the keyboard lock which is always
confirmed with:
EN
"- -" Keyboard lock On.
Display
Displays the set speed
Displays the set speed
Displays the set speed
Displays alternatively HI
"- -" Keyboard lock On.
It displays 24 and the point at the
bottom right flashes once a second,
while the motor is in operation. Press
the key to disable it.
Displays a rotary animation for
5 seconds. "EF" flashes twice in
activation. "EF" flashes once in
deactivation.
Displays the operating speed and the
point on the lower right flashes.
After the procedure, the signal
previously displayed turns off:
FF signals the need to wash the
metallic grease filters. The alarm
comes on after 100 hours of actual
operation of the Hood.
EF signals the need to replace the
active carbon filters and the metallic
grease filters must also be washed.
The alarm comes on after 200 hours of
actual operation of the Hood.
6