Dafra DNPB328 Operation Manual

DNPB328 Operation Manual
PLEASE SPEND 5 MINUTES READING
THESE INSTRUCTIONS BEFORE USING
YOUR NEW RIVNUT TOOL.
TRUST US, IT WILL SAVE YOU TIME AND
INCONVENIENCE IN THE LONG RUN.
READ THIS MANUAL CAREFULLY BEFORE USING THE TOOL!
It is
against injuries.
- This tool should be used ONLY to set blind rivets within the TOOL'S CAPACITY. It MUST
NOT be used for other purposes, such as hammer, etc.
- This tool should be always operated with compressed air supply within the air pressure
range 0.5Mpa ~ 0.7Mpa.
- Always DISCONNECT the air supply from the tool before changing the tool parts, such as
mandrel, etc.
- DO NOT use the tool in the environment described as below:
 fuel and combustion air.
 temperature rapidly rising.
 humidity, rain, water, storm and thunder, lightning.
- When the tool is suspended by the operation hook during use, be sure the tool will not fall.
- When using the tool, always carry protective goggles, protective gloves, safety helmet, and
other necessary protections. It is highly recommended for safety reasons.
- Only use genuine spare parts for maintenance and repairs.
- All repair work must be carried out by skilled personnel, when in doubt, always return the
tool to the distributor.
All manuals and user guides at all-guides.com
IMPORTANT to follow the safety instructions for adequate protection