General Programming Instructions - Panasonic KX-T206 Installation Manual

General Programming Instructions

Default Setting
Required Telephone Set
Extensions Used for
Programming
To Check the
Programmed Data
Before Programming
After Programming
Note
18
This system has a default factory setting. If any of the program-
ming needs to be changed, you can change the setting by system
programming.
You can use any of the following telephones for system program-
ming:
• Proprietary Telephone (PT): KX-T7130, KX-T7030, KX-T7033,
• Single Line Telephone (SLT): tone type
All telephones (except KX-T7130, KX-T7030 and KX-T7033) do
not have display panels, so you cannot check the setting you have
made. Therefore, please use KX-T7130, KX-T7030 or KX-T7033
to check the programming.
System programming can only be performed from extension 21.
Use KX-T7130, KX-T7030 or KX-T7033. When you check the
assignment, set the MEMORY switch on the PT to "PROGRAM".
Enter "#" and the program address.
You cannot check programs #60, #62 to 66 and #68, as they are not
displayed on the display panel.
To enter the system programming mode:
[Off-hook]
To exit the system programming mode:
[Off-hook]
The following programs are available when a proprietary telephone
is connected to extension 21:
• Intercom Alerting Assignment
• Paralleled Telephone Connection
• Executive Busy Override
KX-T7020, KX-T7050, KX-T7055
0
6 2 6
0
6 2 6
0
2 6