universalblue UBH2306-21 User Manual page 44

INSTALLATION WARNINGS
The dimensions and materials of the cabinet or cabinet in which the
built-in oven will be installed must be correct and must be resistant to
temperature increases. Install as shown in the Figure.
 The walls of the furniture in which the oven is installed must
be resistant to heat. The wall panels must be resistant to 100
° C, especially if the side walls are made of wallboard. Plastic
panels or adhesives that are not resistant to this heat can be
deformed and damaged.
 For safety reasons, direct contact with the electric oven parts
should be avoided.
 The insulation and protection parts must be installed in such
a way that they can not be removed with any tool.
 The oven must be installed as in the Figure to provide a more
effective air flow.
 It is recommended to leave a space of at least 40 mm in the
back of the kitchen unit in which the oven is installed.
 A support must be placed under the oven that can support the
weight when placing the oven.
 The rear section of the cab in the kitchen unit should be re-
routed to provide a better fl ow of air.
 It is not recommended to install the device near refrigerators
or freezers, otherwise the performance of these devices would
be affected by the radiated heat.
 Place the device centered in the inlaid cabin
 Open the oven lid and mount the body on the countertop with
four thumbscrews aligning the holes on the sides.
 The oven can be mounted in a cabinet above or below the
counter, if desired

When mounting a built-in electric stove on the countertop
above the oven, the electricity cords of the oven and the stove
must be separated to remove the oven from the stove when
necessary
.
44