Repair/Replacement Of Interface Module (Module 1); Repair/Replacement Of Microprocessor Module (Module 2) - Sailor RM2042 Technical Manual

3 SERVICE
3.9 NECESSARY ADJUSTMENTS AND CHECK AFTER REPAIR
3.9.1

REPAIR/REPLACEMENT OF INTERFACE MODULE (MODULE 1)

REPLACEMENT OF INTERFACE MODULE (MODULE 1)
If the RM2042 is used in a semi automatic system, where the balanced TX AF amplifier is used, it is
necessary to perform section 3.6.1, "ADJUSTMENT OF BALANCED TX AF AMPLIFIER" and then
perform section 3.5, "CHECK OF SYSTEM PERFORMANCE"
However, if the RM2042 is used in a automatic system with RT2047 or RT2048 and if the interface module
is replaced with a new one, which is factory adjusted, it is only necessary to perform section 3.5, "CHECK
OF SYSTEM PERFORMANCE".
REPAIR IN UNBALANCED/BALANCED TX AF AMPLIFIER (MODULE 1)
Perform section 3.6.1, "ADJUSTMENT OF UNBALANCED/BALANCED TX AF AMPLIFIER".
Perform section 3.5, "CHECK OF SYSTEM PERFORMANCE".
REPAIR IN S.P. BUS INTERFACE (MODULE 1)
Connect the RM2042 to the VHF tranceiver (RT2047 or RT2048) by means of the 9 pole SUB-D connector
P2-1 and select the 'VHF CH' menu at the RM2042.
Now try to key-in a channel number with two digits (e.g. channel number 12) and control that the channel
number also change in the display at the VHF tranceiver.
REPAIR IN PRINTER INTERFACE (MODULE 1)
Press the 'FUNC' button and select the 'Print' menu, by pressing 'NEXT'. Use the 'up-arrow' or 'down-
arrow' to select 'Options/setup'. Start the print procedure by pressing 'NEXT' and control that the options/
setup parameters are printed correctly.
REPAIR IN C2149/PC INTERFACE (MODULE 1)
Connect a GPS receiver to the remote control unit C2149 and connect this unit to the VHF DSC RM2042.
Disconnect any GPS input to the RM2042 it self.
Press the 'FUNC' button and select the 'Position' menu. Control that the ships position is continously
opdated and equals the position determined by the GPS receiver.
NOTE! The position update rate may be very slow.
REPAIR IN NMEA INTERFACE (MODULE 1)
Connect a GPS receiver to the VHF DSC unit and control that the ships position is updated as described
above.
3.9.2

REPAIR/REPLACEMENT OF MICROPROCESSOR MODULE (MODULE 2)

REPLACEMENT OF MICROPROCESSOR MODULE (MODULE 2)
If the microprocessor module is replaced with a new one, which is factory adjusted, it is only necessary
to perform section 3.5, "CHECK OF SYSTEM PERFORMANCE".
REPLACEMENT OF SOFTWARE (MODULE 2)
Perform section 3.5, "CHECK OF SYSTEM PERFORMANCE".
REPAIR IN 4.9152 MHz OSCILLATOR (MODULE 2)
Perform section 3.6.2, "ADJUSTMENT OF 4.9152 MHz OSCILLATOR".
Perform section 3.5, "CHECK OF SYSTEM PERFORMANCE".
PAGE 3-10
RM2042
9403