Configuring The Speaker Settings Automatically Based On The Ypao Measurement Results - Yamaha RX-V6ABL User Manual

PREPARATIONS > Configuring the speaker settings
Configuring the speaker settings automatically based on the
YPAO measurement results
Configuring the speaker settings automatically based on the YPAO
multi measurement results
Perform the following procedure to take a measurement when the "Multi Measure" option is selected. It
takes about 15 minutes to measure 8 listening positions.
NOTE
During the measuring process, test tones are output at high volume. You cannot adjust the volume.
(
During the measuring process, stay in a back corner of the room and note the following for accurate measurement.
(
Keep the room as quiet as possible.
(
Do not block sound between the speakers and the YPAO microphone.
(
Do not connect headphones.
(
YPAO multi measurement option cannot be enabled with wireless speakers.
(
1
Select the unit's speaker impedance settings as necessary.
2
Configure the corresponding speaker settings.
3
Set the volume of the subwoofer to half. If the crossover frequency is adjustable,
set it to maximum.
VOLUME
MIN
4
Place the YPAO microphone at your listening position (same height as your ears).
We recommend the use of a tripod as a microphone stand and adjust your listening position
(same height as your ears). You can use the tripod screws to stabilize the microphone.
CROSSOVER/
HIGH CUT
MAX MIN MAX
9
94