Warning!.Ic.rss.general.requirement - Vertex Standard EVX-530 Series Operating Manual

Hide thumbs Also See for EVX-530 Series:
Table of Contents

Advertisement

W
e
nglIsh
r Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and max-
imum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to
other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.
r This radio transmitter (identify the device by certification
number, or model number if Category II) has been approved
by Industry Canada to operate with the antenna types listed
at the right with the maximum permissible gain and required
antenna impedance for each antenna type indicated. Antenna
types not included in this list, having a gain greater than the
maximum gain indicated for that type, are strictly prohibited
for use with this device.
 When transmitting, hold the radio in a vertical position with its microphone 2 inches (5 cm) away from
your mouth and keep the antenna at least 2 inches (5 cm) away from your head and body.
 The radio must be used with a maximum operating duty cycle not exceeding 50%, in typical Push-to-
Talk configurations.
DO NOT transmit for more than 50% of total radio use time (50% duty cycle). Transmitting more than
50% of the time can cause IC RSS General Requirement to be exceeded. To keep the Body Worn configu-
ration with the Vertex Standard CLIP-20 belt-clip, reduce the maximum operating duty cycle still more.
The radio is transmitting when the red LED on the top of the radio is illuminated. You can cause the ra-
dio to transmit by pressing the P-T-T button.
 SAR compliance for body-worn use was only demonstrated for the specific belt-clip (CLIP-20). Other
body-worn accessories or configurations may NOT comply with the IC RSS General Requirement and
should be avoided.
 When operate the radio with the Vertex Standard CLIP-20 belt-clip, make the transmission time as short
as possible, to keep the Body Worn configuration.
EVX-530 S
O
EriES
pErating
! Ic rss g
arnIng
M
anual
r
eneral
equIrement
Vhf m
odel
ATV-16A: 2.15 dBi, 50-ohm
ATV-16B: 2.15 dBi, 50-ohm
ATV-16C: 2.15 dBi, 50-ohm
ATV-16XL: 2.15 dBi, 50-ohm
uhf m
odel
ATU-16A: 2.15 dBi, 50-ohm
ATU-16B: 2.15 dBi, 50-ohm
ATU-16C: 2.15 dBi, 50-ohm
ATU-16F: 2.15 dBi, 50-ohm
ATU-16BS: 2.15 dBi, 50-ohm
ATU-16DC: 2.15 dBi, 50-ohm
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Evx-531Evx-534Evx-539Evx-531-d0Evx-534-d0Evx-531-g7

Table of Contents