Monte Carlo Fan Company 5BR52 D Series Owner's Manual And Installation Manual page 6

27
Place blade bracket onto blade
by aligning the 3 holes on blade
as shown.
30
Loosen 3 and remove 1 preassembled
scews from the plate on motor. Save
screw for later use.
33
Attach capacitor and wattage
l i m i t e r o n t o l i g h t p a n b y
preadhered double-sided foam
tap as shown.
© 2013 Monte Carlo Fan Company
28
Install blade bracket with blade by
3 blade screws provided. Tighten
securely. Repeat this process for
remaining blades.
31
Place light pan over wires from motor.
Attached light pan on to the plate on
motor, aligning the keyhole slots with
the preassembled screws on the plate.
Twist clockwise till lock. Install the screw
removed in step 30. Tighten all screws
securely.
34
L o o s e n 2 a n d r e m o v e 1
preassembled screw from
the light pan. Save screw for
later use.
6
29
Shipping
stabilizer
Check motor for shipping stabilizers
and remove if present. Install the blade
assembly to motor using the screws
pre-installed. Tighten screws securely.
Repeat this process for remaining blade
assemblies.
32
Hook
Connect plug from fan to plug
from light pan. Make sure the
plugs are hooked together.
35
Remove finial and screw nut from
light fixture.
Connect white wire from light pan
to white wire from light fixture.
Connect blue wire from light pan to
black wire from lighgt fixture.
7/1/2013