Monte Carlo Fan Company 5BR52 D Series Owner's Manual And Installation Manual page 3

1
Before you begin installing the fan, Switch
power off at Service panel and lock service
disconnecting means to prevent power
from being switched on accidentally. When
the service disconnecting means cannot
be locked, securely fasten a prominent
warning device, such
service panel.
4
Downrod Mount Installation
Loosen 2 screws on yoke to allow
down rod to slip into yoke.
7
Place yoke cover over downrod
as shown.
© 2013 Monte Carlo Fan Company
2
Before installing this fan make sure the
outlet box is properly installed to the house
structure. To reduce the risk of fire, electric
shock, or personal injury, mount to outlet
box or supporting system acceptable for fan
support.
as a tag, to the
(Mounting must support at least 35 lbs.)
5
Remove keeper pin and cross
pin from yoke, and save for later
use.
8
Thread the leadwires and safety cable
through the downrod.
3
Use metal outlet box suitable for fan support
and use only the screws provided with the
outlet box
attaching fan to outlet box, ensure the outlet
box is securely fastened by at least two points
to a structural ceiling member ( a loose box
will cause the fan to wobble). Remove the
two outlet box screws provided with the box,
aligning the holes of the mounting bracket
with the holes of the outlet box. Re-install the
2 outlet box screws securely.
6
Place canopy over downrod.
9
Insert downrod into the yoke on top of fan
body. Align the hole in the downrod with the
hole in the yoke. Insert cross pin through
yoke and downrod until point appears on the
other side.
3
(must support 35 lbs). Before
7/1/2013