SPOT GEN3 User Manual page 18

RF Exposure: Per EN 62479:2010, the SPOT Gen4 spectral power density at a distance of 0.1 cm is
calculated to be 3.33 mW/cm² , which is less than the maximum allowable limit for uncontrolled exposure (
8.05 mW/cm²). If concerned about RF exposure during use, place the SPOT Gen4 anywhere it is not directly
touching your body after functions have been activated. The RF exposure level drops off dramatically with
distance from the SPOT Gen4.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
This device complies with FCC Part 25.213.
This device automatically adjusts its transmission frequency according to its location and is compliant with
international regulatory requirements.
The SPOT Gen4 has been so constructed that the product complies with the requirement of Article 10(2)
as it can be operated in at least one Member State as examined and the product is compliant with Article
10(10) as it has no restrictions on putting into service in all of the EU except Ireland. The SPOT Gen4 cannot
be marketed in Ireland.
IE
Not to be Marketed in the Republic of Ireland
17