SPOT GEN3 User Manual page 17

* Transmit Frequencies: 1611.25 Mhz - 1618.75 Mhz (4 Channels)
* Max Power Out: 23.52 dBm EIRP
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures: a) Reorient
or relocate the receiving antenna. b) Increase the separation between the equipment and receiver. c) Connect
the equipment into an outlet on a circuit different from that to which the receiver is connected. d) Consult the
dealer or an experienced radio/TV technician for help.
This device generates radio frequency energy at a low duty cycle (<1%). Transmitter on-time is dependent
on configurable operational modes with a maximum of two 1.44 second long transmissions per five minute
period. Satellite transmissions are 23.5 dBm EIRP. Based on these figures, the device has been exempted
from SAR testing.
In order to comply with FCC/ISED RF Exposure requirements, this device must be installed to provide at
least 20 cm separation from the human body at all times.
16