Sinclair AW-TDF190-H31 Installation And Operation Manual page 7

1 - GENERAL INSTRUCTIONS
shown on the serial number label). Verify
that the network has characteristics
conforming to the data shown on the
serial number label .
Make sure that the unit supply line is
selected at start.
Shelter the cables using adequate
measure fairleads.
Before starting work, verify that the
sectioning device at the start of the unit
power line is open, blocked and equipped
with sign warning.
First create the earthing connection.
After wire connection, check it again and
make sure the correctness before power
on.
Prior to powering the unit ensure that all
the protections that were removed during
the electrical connection work have been
restored.
Signal lines/data-lay
Do not overpass the maximum power
allowed, which varies, according to the
type of signal.
Lay the cables far from power cables or
cables having a different voltage and that
are able to emit electromagnetic
disturbances. Do not lay the cable near
devices which can generate
electromagnetic interferences.
Do not lay the cables parallel to other
cables; cable crossings are possible, only
if laid at 90°.
Connect the screen to the ground, only if
there aren't disturbances .
Guarantee the continuity of the screen for
the entire extension of the cable.
Respect impendency, capacity and
attenuation indications.
MODIFICATION
All unit modifications will end the
warranty coverage and the manufacturer
responsibility.
BREAKDOWN/MALFUCTION
Disable the unit immediately in case of
breakdown or malfunction.
Contact a constructor certified assistance
service.
Use original spares parts only.
USER TRAINING
The installer has to train the user on :
- ON / OFF
- set points change;
- standby mode;
- Maintenance;
- what to do / what not to do in ca-
se of breakdown.
DATA UPDATE
Continual product improvements may
imply manual data changes
Visit manufacturer web: www.airwell-
pro.fr site for updated data.
7