Sinclair AW-TDF190-H31 Installation And Operation Manual page 14

4 - RECEPTION
4.1 - DELIVERY CONTROL
Before accepting the delivery you have to check:
•
that the unit hasn't been damaged during transport.
•
Check that the materials delivered correspond with that
indicated on the transport document comparing the data
with the identification label 'A' positioned on the packa-
ging.
In case of damage or anomaly:
•
Write down on the transport document the damage you
found and quote this sentence: "Conditional acceptance
clear evidence of deficiencies/damages during transport".
•
Contact supplier and the carrier by fax and registered mail
with advice of receipt.
Any disputes must be made within the 8 days following the
delivery. Complaints after this period are invalid.
HANDLING
4.2 -
The following examples are indications the choice of the
means and of the handling modes will depend on factors.
Verify the lifting equipment's load-bearing capacity: the ship-
ped unit weighs
Unit
190
190S (with solar)
300
300S (with solar)
Identify critical points during handling (disconnected routes,
flights, steps, doors).
Shipping weight
114
kg
138
kg
131
kg
158
kg
Use protection (A) to avoid the unit damaging
Stair climbing trolley.
When transporting the unit, do not carry it by holding on to the
top part of the circuit.
This unit is heavy, it need to be carried by two or more per-
sons, otherwise might cause injury and damage.
In order to avoid scratch or deformation of the unit surface,
apply guard boards to the contacting surface.
No contact of fingers and other things with the vanes.
While moving it, do not tip the unit to an angle less than 45°
and keep it in a vertical position during installation.
If the unit has been tipped during transport, wait at least 2
hours before starting it up
Maximum inclination
14