Operations Flow - Panasonic i-PRO WJ-NX300K Installation Manual

Operations flow

• Professional knowledge on and experience in network and the HDD are required for
the settings and changes of the operation.
• The main monitor is required for the settings.
* The settings can be done through a web browser on the PC (Refer to the Operating
Instructions (PDF)).
• The PC is required for reading the Important Information, the Operating Instructions
(PDF) and camera settings.
• The operations flow is explained using the single mode operation of the HDD.
Obtain the license (Registration Key)
1
☞ Page 12 and Activation Key Card
Installation of the hard disk drive
2
3
4
Turn on the devices
5
Register the license (Registration Key)
6
10
☞ Page 13
Rack mounting
☞ Page 15
Connections
☞ Page 17
☞ Page 27
☞ Page 29
Obtain the "Registration Key" of the recorder by following the
instructions on the provided Activation Key Card. To
increase the number of connected cameras, or to use the
secure function, the business intelligence function or RAID
extra function, get the registration key of the additional
license according to the appropriate Additional Kit (option).
The obtained "Registration Key" will be used in Step 6.
Install the hard disk drives in the recorder.
Install the recorder and the extension unit in the rack.
(☞ Page 15) Go to step 4 when not installing it in the rack.
Connect the recorder to each device.
Turn on the power to launch in the following order.
①Turn on the power of the camera and the monitor.
②Turn on the power of the extension unit.
③Turn on the power of the recorder.
Register the Registration Key of the recorder. If necessary,
register the "Registration Key" for each Additional kit.
Important:
• Be sure to register the "Registration Key" of the recorder.
If the "Registration key" of the recorder is not registered,
the Additional Kit cannot be registered.
After registration, click [Restart] button on the license
registration screen to reboot the recorder and activate the
license.