Advertisement
Speedometer calibration with a speed signal wire:
*To simplify the setup procedure, please download the IOS or Android app 'Dakota Digital Accessory'*
To operate the setup procedure, the orange wire needs to touch ground.
The orange wire can be wired to one side of the enclosed push button switch, and the other side of
the switch goes to any ground. The switch should be mounted in the car, with easy driver access.
The display on the ECD-200 will indicate the setup mode, and the ECD-200 will also move the
speedometer needle to different positions during the setup, without having to see the control unit.
The four setup mode indicators are:
• 10 MPH for cable reverse - LED:
• 30 MPH for AutoCal
• 20 MPH for Adjust
• 45 for Preset
The speedometer needle will go to zero for menu options that require the display on the ECD-200 for
selection.
The needle position may not point exactly on the stated speedometer number, but will be close.
Entering setup:
• Press and hold the switch, then start the engine for speed calibration.
• The speedometer needle will move up to about 15 MPH (24 km/h) and the ECD-200 display
will show and then '- -'.
• Release the switch, after the engine is running.
• The needle should move up to about 10 MPH (16 km/h) for cable reverse.
• You may tap the switch to move the needle to: 20 for Adjust, 30 for Autocal, 45 for Preset, or 0.
When the needle moves to 0 the ECD-200 LED will continue through setup menu options.
Reverse (10 MPH) – LED:
• Needle should be pointing to 10 MPH (16 km/h).
• If the needle is not moving up, press and hold the switch four seconds to reverse direction
• Tap the switch to move to AutoCal, once the needle is at 10 MPH
AutoCal (30 MPH): - LED:
• Needle should be pointing to 30 MPH (48 km/h).
• Press, and hold, the switch until the needle drops to 0 MPH.
• Release the switch.
• The needle will move up to about 10 MPH (16 km/h) – LED: ""
• Begin driving a marked mile.
• The needle will move up to about 30 MPH while it is receiving a speed signal, and will drop to
about 10 MPH when no signal is present.
o The LED will start at "" and count up with pulses. "" = 8,000 pulse per mile
• Press and hold switch as you "cross finish line", or stop at the end of the mile, until the speed
drops to 0 MPH.
• Release the switch and the unit will begin normal operation.
o The LED will change to a ":", with the ":" alternating during operation
• If the sender type is set to "
- LED:
- LED:
- LED:
" the LED will display "
4
" and the needle will not move
MAN# 650704A
Advertisement
