Table of Contents
Advertisement
TV-SYSTEM
(S-VIDEO/VIDEO only)
This should normally be set to
"AUTO". If the signal is of such poor
quality that the correct format
cannot be automatically
distinguished, change the setting
manually to the required TV system.
NOTE:
B When set to "AUTO", the
projector automatically
distinguishes between
NTSC/NTSC 4.43/PAL/PAL60/
PAL-M/PAL-N/SECAM signals.
46-E
NGLISH
ADVANCED MENU
Picture settings can be adjusted in
more detail.
Press the ENTER button to display
the "ADVANCED MENU"
GAMMA HIGH/MID/LOW
These items are for adjusting the
gradation of the bright, medium and
dark scenes in the projected image
respectively.
CONTRAST R/G/B
These items are for adjusting the
colour temperature of the white
areas of the projected image by
changing each level.
BRIGHT R/G/B
These items are for adjusting the
colour temperature of the black
areas of the projected image by
changing each level.
COLOUR MANAGEMENT
This item is for adjusting the
selected colours of the projected
image to suit your preference, and
saving the settings. Refer to page
36 for details.
MEMORY SAVE
Press the ENTER button to display
the "MEMORY SAVE" menu.
The settings adjusted in "PICTURE"
menu can be saved. Press the F or
G button to select the number
("MEMORY 1/2/3") in which you
want to save the setting, and then
press the ENTER button.
The confirmation screen will then be
displayed. Press the I or H button
to select "OK" and then press the
ENTER button.
The current picture setting will be
saved.
NOTE:
B You can save up to 3 settings
for each of the 2 signal groups
described below (up to 6
settings can be saved).
S-VIDEO, VIDEO, YP
P
,
B
R
SCART, HDMI (except for
VGA480 signals) and 1 125
(1 080)/60i and 1 125
(1 080)/50i signals from PCs
VGA480 HDMI signals and PC
[except for 1 125 (1 080)/60i
and 1 125 (1 080)/50i signals]
MEMORY LOAD
Press the ENTER button to display
the "MEMORY LOAD" menu.
(If any setting is not saved in the
"MEMORY SAVE" menu, the
"MEMORY LOAD" menu will not be
displayed.)
Refer to page 34 on how to retrieve
the saved settings.
SIGNAL MODE
(PC/YP
P
/HDMI only)
B
R
This displays the type of signal
which is currently being projected.
Refer to the list on page 64 for
details on each type of signal.
Projecting sRGB-
compatible pictures
sRGB is an international colour
reproduction standard (IEC61966-2-
1) established by the International
Electrotechnical Commission (IEC).
If you would like the colours in
sRGB-compatible pictures to be
reproduced more faithfully, make
the following settings.
# Select "PICTURE MODE" and
set it to "NATURAL".
$ Press the MENU button or
RETURN button on the remote
control unit to display the sub-
menu for the "PICTURE" menu,
and then press the NORMAL
button on the remote control
unit.
% Select "LAMP POWER" in the
"OPTION" menu and set it to
"HIGH".
E
-47
NGLISH
Advertisement
Table of Contents
