User Mode; Adjusting The Water Softener; The Water Hardness Table - Zanussi ZDT26040FA User Manual

Table of Contents

Advertisement

Available languages

Available languages

Stop the countdown of Delay option.
Bring the appliance back to the programme
selection mode.
To CANCEL:
Press and hold CANCEL until the control panel
indicates the appliance is in the programme
selection mode.

USER MODE

Settings available in the user mode:
The level of the water softener according to the
water hardness.
Activation or deactivation of the rinse aid empty
notification.
Activation or deactivation of the acoustic signal
indicating the end of a programme.
Activation or deactivation of AirDry.
Before entering the user mode, make sure the
appliance is in the programme selection mode.
To enter the user mode:
Press and hold simultaneously
least 3 seconds.
The indicators:
,
As the appliance stores the saved settings, there is
no need to configure it before every cycle.

THE WATER HARDNESS TABLE

German degrees
(°dH)
47 -50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
<4
1) Factory setting
2) Do not use salt at this level.
24
and
,
, and
start flashing.
French degrees
(°fH)
84 - 90
76 - 83
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
<7

ADJUSTING THE WATER SOFTENER

Make sure the appliance is in user mode.
1. Press
The indicators
The indicator
The display shows the current setting: e.g.
2. Press
of the button
one. After reaching level 10, the count starts
from level 1
3. Press the on/off button to confirm the setting.
If you use multi-tablets containing salt
and the hardness of your water is
lower than 21°dH, you can set the
lowest water softener level. It
deactivates the salt refill indicator.
If you use standard detergent or
for at
multitablets without salt, set the proper
water hardness level to keep the salt
refill indicator active.
mmol/l
8.4 - 9.0
7.6 - 8.3
6.5 - 7.5
5.1 - 6.4
4.0 - 5.0
3.3 - 3.9
2.6 - 3.2
1.9 - 2.5
0.7 - 1.8
<0.7
.
,
and
still flashes.
= level 5.
to change the setting. Each pressing
increases the level number by
Clarke degrees
58 - 63
53 - 57
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
are off.
Water softener
level
10
9
8
7
6
1)
5
4
3
2
2)
1

Advertisement

Table of Contents
loading

Table of Contents