Assembly; Viii. Assembly; Beginning Assembly; Stand - Grizzly G1182 Instruction Manual

VIII. ASSEMBLY

A. BEGINNING ASSEMBLY
Most of your G1182 6'' Jointer has been assem-
bled at the factory, but some parts must be
assembled or installed after delivery. We have
organized the assembly process into steps.
Please follow along in the order presented here.
TOOLS REQUIRED: You will need a high quality
square, a long straightedge, 10mm, 12mm and
14mm open end wrenches, and a 3mm Allen
wrench.
All die-cut metal parts have a sharp edge
(called "flashing") on them after they are
formed. This is removed at the factory.
Sometimes, though, a bit of flashing might
escape inspection. Please examine the
edges of all metal parts before handling
them.
DO NOT attempt any step of assembly,
adjustments, or maintenance while your
Model G1182 is running. Ensure that the
switch is off, power is disconnected and
moving parts have stopped before making
adjustments. Failure to comply may result in
serious personal injury.
G1182 6" Heavy-Duty Jointer
B. STAND
For reference, assemble the stand so the dust
chute end is on your left when facing the stand,
and the power switch is on your right.
1. Begin by attaching the two ends to the front
panel with the machine screws and washers
provided. Figure 2.
®
Figure 2. Attachment of the two end panels.
2. Mount the two dust chute sides to the dust
chute end as shown in Figure 3. Note that
the flanges are pointed away from the inside
of the chute. Do not fully tighten the screws
yet.
Figure 3. Attaching the dust chute.
-9-