Jointer To Stand; V-Belt - Grizzly G1182 Instruction Manual

VIII. ASSEMBLY (Continued)
6. The power switch is already installed on the
right hand panel of the stand. To complete
the wiring, it is first necessary to remove the
switch assembly from the stand. Remove the
®
two Phillips head screws holding the metal
mounting plate to the stand. The entire
switch can then be pulled out of the stand.
Next remove the switch box from the back of
the switch. Locate the cord which has been
pre-wired to the motor. Take the end with the
connectors and feed it through the hole in
the switch box. Connect the green ground
wire to the green ground connection at the
switch. Now slide the wire connectors onto
the tabs on the switch, matching wire colors.
Reassemble the junction box to the back of
the switch, then install the switch assembly
back into the stand.
7. Flip the stand upright and securely tighten all
fasteners on the stand and dust chute.
This equipment must be grounded. Please
ensure that this machine is continuously
grounded from the motor to the machine
frame and then to a known ground. Verify that
any existing electrical outlet and circuit you
intend to plug into is actually grounded. If it is
not, it will be necessary to run a separate 12
A.W.G. copper grounding wire from the outlet
to a known ground. Under no circumstances
should the grounding pin from any three-
pronged plug be removed. Serious injury
may occur.
G1182 6" Heavy-Duty Jointer
C. JOINTER TO STAND
This step will require at least two people. To
mount the jointer to the stand:
1. Lift the main unit onto the stand, making sure
to position the cutterhead pulley over the slot
in the top of the stand.
2. Carefully align the mounting holes in the stand
with the threaded holes in the base of the join-
ter. Secure the jointer to the stand using the
3 3
three ⁄ " - 16 x ⁄ " hex bolts and
8 4
ers provided.
D. V-BELT
To install the V-Belt:
1. Loosen the motor mount bolts located inside
the dust chute and slide the motor up until
you can attach the V-Belt to the pulleys. See
Figure 7.
Figure 7. Motor mounts inside dust chute.
3
⁄ " flat wash-
8
-11-