Related Manuals for Draytek VigorSwitch Q2200x
Summary of Contents for Draytek VigorSwitch Q2200x
- Page 1 VigorSwitch Q2200x L2+ Managed Switch Quick Start Guide Version: 1.0 Firmware Version: V2.7.1 (For future update, please visit DrayTek web site) Date: July 6, 2022...
- Page 2 Intellectual Property Rights (IPR) Information © All rights reserved. This publication contains information that is protected Copyrights by copyright. No part may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language without written permission from the copyright holders. The following trademarks are used in this document: Trademarks ...
- Page 3 EU Declaration of Conformity We DrayTek Corp. , office at No.26, Fushing Rd., Hukou, Hsinchu Industrial Park, Hsinchu 303, Taiwan , R.O.C., declare under our sole responsibility that the product Product name: 16-port 2.5G with 4-port 10G SFP+ up-link Switch ...
-
Page 4: Regulatory Information
Web registration is preferred. You can register your Vigor switch via https://myvigor.draytek.com. Firmware & Tools Updates Due to the continuous evolution of DrayTek technology, all switches will be regularly upgraded. Please consult the DrayTek web site for more information on newest firmware, tools and documents. https://www.draytek.com... - Page 5 VigorSwitch Q2200x Quick Start Guide Rack Mount Kit (brackets) Console Cable The type of the power cord depends on the country that the switch will be installed. UK-type Power Cord EU-type Power Cord USA/Taiwan-type Power Cord AU/NZ-type Power Cord If any of these items is found missing or damaged, please contact your local...
- Page 6 Port 1 to 16 Port 17 to 20 (2.5GbE RJ45) (SFP+) Status Explanation An alert for system failure due to overheating On (Red) or wrong voltage. Monitor The device is in normal condition and running normally. The switch finishes system booting and the On (Green) system is ready.
- Page 7 Port 17 to Port 20 are used for fiber Port 17 ~ 20 (SFP+) connection. Console Used to perform telnet command control. Power inlet for AC input (100~240V/AC, 50/60Hz).
- Page 8 This section will guide you to install the switch through hardware connection and configure the switch’s settings through web browser. Before starting to configure the device, you have to connect your devices correctly. A hierarchical network with minimum levels of devices may reduce the timing delay between server and client station.
- Page 9 The switch can be installed easily by using rack mount kit. Fasten the rack mount kit on both sides of the VigorSwitch using specific screws. Then, install the VigorSwitch (with rack mount kit) on the 19-inch chassis by using other four screws.
- Page 10 Before using the switch, perform the following steps: 1. Set up a physical path between the configured the switch and a PC by a qualified UTP Cat. 5e cable with RJ-45 connector. If a PC directly connects to the switch, you have to setup the same subnet mask for Default values of the managed switch are listed as follows: PC and the switch.
- Page 11 2. After configuring correct IP address on your PC, open your web browser and access switch's IP address. The home page of VigorSwitch will be shown as below:...
- Page 12 This DrayTek product uses software partially or completely licensed under the terms of the GNU GENERAL PUBLIC LICENSE. The author of the software does not provide any warranty. A Limited Warranty is offered on DrayTek products. This Limited Warranty does not cover any software applications or programs.
Need help?
Do you have a question about the VigorSwitch Q2200x and is the answer not in the manual?
Questions and answers