Canon Super G3 FAX board-AL1 Service Manual page 19

5
Service Mode Service Mode > Outline > Using Service Mode
For instance, in the case of #1 SSSW, the following holds true; key functions and operations
are the same for all screens:
Menu Num Ncu Type
Sssw
SW01 00000000
SW02 10000000
SW03 00000000
SW04
10000000
SW05 00000000
SW06
10000000
SW07 00000000
SW08 10000000
Previous Page/Next Page key
• If you want to change 0 to 1 or 1 to 0 on a bit switch, press the desired bit (number) directly.
• If you want to store a change or execute an item, press the OK key.
• Use the keypad to enter a numerical value.
• To return to the previous level of selection, press the Reset key.
Caution:
If you changed a setting in service mode, be sure to turn off and then on the power
(making sure that you first turn off the control panel switch and then the main power
switch).
The settings made in service mode are stored on the hard disk. The settings associated
with the Board are loaded to the G3 fax control PCB only when the main power is tuned
on, thus requiring you to turn it off and then on after making a change.
5 Service Mode > Outline > Using Service Mode Service Mode
ISDN Print Clear Test Report
<READY>
<1/7>
OK
Press to accept the current input.
F-5-2
5-3
5-3