Table of Contents
Advertisement
Home Connect
en
The hob is connected to the home network if the
symbol no longer flashes but is lit up on the
D
cooking position display.
The appliance automatically tries to connect to the
app and the
setting appears.The
•'ƒ
flashes on the control panel.
Start the app on the mobile device and follow the
5.
instructions for manual network registration.
The registration procedure has been completed once
the
value appears on the cooking position display.
‹
Home Connect settings
You can adjust Home Connect to suit your
requirements at any time.
In the basic settings for your hob, navigate to the Home
Connect settings to display network and appliance
information.
Symbol
Function
Registration in the home network (WLAN)
•'‚
Not connected /disconnect network.
‹
Connect automatically.
‚
Connect manually.
ƒ
Connected.
„
Connection to app
•'ƒ
Not connected.
‹
Connect.
‚
Connect to WLAN
•'„
Radio module switched off.
‹
Radio module switched on.
‚
Settings via app
•'...
Switched off.
‹
Switched on.*
‚
Software update
•'†
Update available and ready for installation.
‚
Starting installation.
ƒ
Remote access by Customer Service
•'‡
Not permitted.
‹
* Basic setting
26
Symbol
‚
•'ˆ
value
‚
‹
‚
ƒ
„
•'‰
‹
‚
* Basic setting
Notes
The
■
connected to the home network.
The
■
has once connected to a network.
The
■
available.
The
■
Service is attempting to connect to the appliance.
You can end this at any time after granting access.
The
■
there is a connection to WLAN.
Deactivating WLAN
If WLAN is activated, you can use the Home Connect
functions.
Note:
In networked standby mode, your appliance requires
max. 2 W.
Touch the
1.
Product information will be displayed.
Touch the
2.
setting appears.
‚
Set the
3.
WLAN is deactivated and the
panel goes out.
Function
Permitted.
WLAN signal strength
Not connected to home network (WLAN).
Signal strength 1 (poor)
Signal strength 2 (moderate)
Signal strength 3 (good)
Connection to Home Connect server
Not connected.
Connected.
setting is only displayed if the appliance is
•'ƒ
setting is only displayed if the appliance
•'„
setting is only displayed if an update is
•'†
setting is only displayed if Customer
•'‡
and
settings are only displayed if
•'ˆ
•'‰
symbol for 4 seconds.
0
symbol repeatedly until the
0
lights up on the cooking position display.
value on the control panel.
‹
•'„
symbol on the control
D
Advertisement
Table of Contents
