Table of Contents
Advertisement
Quick Links
DIGI-BSR-4K Installation Guide
F rmw re
L
R
TX RX
12V DC
Ethernet1
Ethernet2
HDBT In
IR In
IR Out
HDMI Out
S/PDIF Out
Aud o Out
RS232
The Intelix DIGI-BSR-4K extends HDMI over a single solid core shielded Category 5e or
greater cable using the Valens VS100RX HDBaseT chip and scales the source content up
or down to the native resolution of the connected display. The DIGI-BSR-4K supports
1080p, full 3D or 4k x 2k video signals up to 100 meters (328 feet) including multichannel
audio and HDCP 1.4. Built-in surge protection and diagnostic LEDs ensure hassle-free
and robust installations. Additional connections include bidirectional IR, bidirectional
RS232, Ethernet pass-through with a 2-port network switch, and analog and digital
audio de-embedding.
The DIGI-BSR-4K requires local power, but it can provide power to a compatible
HDBaseT transmitter. The power supply is included with the extender. The bidirectional
wideband IR, bidirectional RS232, and Ethernet pass-through capabilities make the
DIGI-BSR-4K compatible with most control systems. The IR emitter (DIGIB-EMT)
and IR receiver (DIGIB-EYE) are sold separately. The two-port network switch on the
DIGI-BSR-4K allows a second device to share the 100BaseT Ethernet pass-through
connection without adding additional hardware to the installation.
The DIGI-BSR-4K is compatible with all Intelix HDBaseT product offerings and any
product that meets the HDBaseT specifications.
Advertisement
Table of Contents
Related Manuals for Intelix DIGI-BSR-4K-BSTK
Summary of Contents for Intelix DIGI-BSR-4K-BSTK
- Page 1 Aud o Out RS232 The Intelix DIGI-BSR-4K extends HDMI over a single solid core shielded Category 5e or greater cable using the Valens VS100RX HDBaseT chip and scales the source content up or down to the native resolution of the connected display. The DIGI-BSR-4K supports 1080p, full 3D or 4k x 2k video signals up to 100 meters (328 feet) including multichannel audio and HDCP 1.4.
-
Page 2: Fcc Statement
FCC Statement This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. It has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. -
Page 3: Receiver Front
Receiver Front 1 2 3 4 5 F rmw re Power Indicator Scaler Indicator Device Status Indicator HDCP Activity Indicator HDBaseT Link Indicator Firmware Update Port Receiver Rear TX RX 12V DC Ethernet1 Ethernet2 HDBT In IR In IR Out HDMI Out S/PDIF Out Aud o Out... - Page 4 Default Device Behavior The DIGI-BSR-4K will convert any incoming HDBaseT signal and scale the video signal to match the native resolution of the connected display. The scaler chip in the DIGI-BSR-4K presents an EDID of 3840x2160 at 30 Hz to the source device connected to the HDBaseT transmitter. Other video resolutions are included in the EDID table to provide the greatest amount of compatibility with the source device.
-
Page 5: Installation Instructions
Installation Instructions The following instructions describe the installation process for a point- to-point installation. The procedure is similar for compatible HDBaseT components. In the event the DIGI-BSR-4K cannot provide power over the HDBaseT cable connection, the HDBaseT transmitter will require a local power supply. -
Page 6: Rs232 And Tcp/Ip Commands
RS232 and TCP/IP Commands RS232 Settings: 57600 baud, 8 Data bits, 1 Stop bit, Parity = None TCP/IP Settings: User defined IP address (default IP address: 192.168.2.128), port 23 There is a carriage return (hex 0D) and line feed (hex 0A) at the end of every command and response. -
Page 7: Ip Addressing Commands
RS232 to Display Commands Description Command Response SET BAUD xxx BAUD xxx Set Baud Rate to Display (9600, 57600, 115200) DONxxxxxxxxxxxxxxxxx DONxxxxxxxxxxxxxxxxx Set RS232 Display On Command DON? DONxxxxxxxxxxxxxxxxx Get RS232 Display On Command DOFxxxxxxxxxxxxxxxxx DOFxxxxxxxxxxxxxxxxx Set RS232 Display Off Command DOF? DOFxxxxxxxxxxxxxxxxx Get RS232 Display Off Command... - Page 8 Digitalinx is a brand of Liberty AV Solutions. 11675 Ridgeline Dr. Colorado Springs, CO 80921 Toll-Free: 800-530-8998 Fax: 719-260-0075 www.libav.com rev 170424...