Mitsubishi Electric PD-6130 Service Manual page 6

does not get any shock or stress.
(7) If one touches the connector of the flexible cable exposed to the rear side of the PDP module, there is
danger of causing a poor contact. As such, it must be handled with utmost care. In addition, the flexible
cable is very weak in mechanical strength. Therefore, this cable must not be touched during handling.
(8) The panel surface of the filter and the PDP module is easy to be hurt. These components should be
handled very carefully not to press or rub them with a hard thing. Never put them on a hard thing with the
panel surface faced downwards.
(9) When the panel surface of the PDP module is contaminated, gently wipe off the contaminant with a piece
of soft dry cloth. Liquid-state contamination can be removed by lightly pressing it, without rubbing it. If it is
difficult to remove the contamination, use a piece of cloth soaked with a neutral detergent. The cloth for
wiping off should be clean. Never use the same cloth repeatedly. If a cleansing detergent or water drops
should enter the module interior or be attached to the module surface other than the display plane at the
time of cleaning, this will give rise to the destruction of the product when the product is energized.
(10) Refer to the "Instruction Manual" in regard to contamination in the filter and the cabinet.
(11) When transporting this product, use the packing materials specified in the list of parts. Once used, such
packing materials should not be used again.
(12) This product is composed of a variety of parts, such as those made of materials like glass, metal, plastics,
etc., and those like a lithium battery (circuit symbol of the MAIN PWB: BA9501), etc. Therefore, when
abandoning this product, this should be done in accordance with the relevant law of the nation or an
autonomous body.
2-4