Sony MB-806A Service Manual page 32

Switch and Control Setting
Front panel (Tuner [1])
Channel setting:
CE62 model; Group 00, 6301 channel (806.125 MHz)
CE69 model; Group 00, 6933 channel (858.125 MHz)
AU66 model; Group00, 6701 channel (799.250 MHz)
Muting: OFF
Rear panel
ATT (ANTENNA A, B) switch: 0 dB
Procedure
Step 1: Preparation
Set the signal generator as follows:
Signal generator setting
FREQUENCY(carrier frequency):
CE62 model; 806.125 MHz
CE69 model; 858.125 MHz
AU66 model; 799.250 MHz
RF OUTPUT (Output level): 60 dBuV
MODULATION (Modulation frequency): 1 kHz
DEVIATION (Frequency deviation): ± 5 kHz
Step 2: Tuner [1] (Tuner unit 1) adjustment
n
The adjustment procedures describe that the WRU-806A
(to be adjusted) is installed into the Tuner [1] slot on the
MB-806A.
(1) Connect the audio analyzer to the TUNER OUTPUT 1
connector via MIC amp.
(2) Connect the signal generator to the ANTENNA A IN
connector with DC cut fixture.
(3) Adjustment (ANTENNA A IN side adjustment)
Specification: Output level (level meter indication
level) = _21 dBm ± 0.5 dB (at 600 Z
loaded)
Adjustment: 1RV202/RF-92 board (Tuner unit 1)
(4) Connect the signal generator to the ANTENNA B IN
connector with DC cut fixture.
(5) Adjustment (ANTENNA B IN side adjustment)
Specification: Output level (level meter indication
level) = _21 dBm ± 0.5 dB (at 600 Z
loaded)
Adjustment: 1RV201/RF-92 board (Tuner unit 1)
n
The output level difference between the ANTENNA
A side and the ANTENNA B side should be within
0.3 dB.
3-6
EMF
(= _53 dBm)
Step 3: Tuner [2] to [6] adjustment
When the WRU-806A Tuner Unit is installed in the Tuner
[2] (Tuner unit 2) to Tuner [6] (Tuner unit 6) of the MB-
806A, perform the adjustments from procedures (1) to (5)
of "Step 2. Tuner [1] (Tuner unit 1) adjustment" on the
respective tuner units that are installed in the MB-806A.
When performing the above described adjustments change
the following details as shown below of the "Step 2. Tuner
[1] (Tuner unit 1) adjustment."
Tuner [1] adjustment → Tuner [2], [3], [4], [5], or [6]
adjustment
Measurement:
TUNER OUTPUT 1 → TUNER OUTPUT 2, 3, 4, 5, or 6
Adjustment:
→ Tuner unit 2, 3, 4, 5, or 6
Tuner unit 1
Step 4:
After completing adjustment, turn off the MB-806A power
switch and perform the followings.
(1) Remove the WRU-806A Tuner Unit to be adjusted
from the MB-806A.
(2) Attach the upper side case lid to the tuner unit, and
insert the WRU-806A Tuner Unit to be adjusted to the
slot of the MB-806A.
MB-806A (CE)
WRU-806A (CE, AU)