Haier HMV1652 Installation Instructions Manual page 25

7. Tighten center screw completely.
8. Tighten the outer two screws to the top of the microwave oven. (While
tightening screws, hold the microwave oven in place against the wall and the top
cabinet).
Install grease filters.
For instructions, see the User Manual packed with the microwave.
METHOD C - RECIRCULATING (NON-VENTED, DUCTLESS)
IMPORTANT:
•
Make sure the screws for the blower motor and blower plate are securely
tightened when they are reinstalled. This will help to prevent excessive vibration.
•
Make sure the motor wiring has been properly routed and secured, and that the
wires are not pinched.
Attach the mounting plate to the wall using toggle bolts.
NOTE: At least one wood screw must be used to attach the plate to a wall stud.
1. Remove the toggle wings from the bolts.
2. Insert the bolts into the mounting plate through the holes designated to go into
drywall and reattach the toggle wings onto each bolt.
23