CAUTION: Be careful to avoid pinching fingers between the back of the
mounting plate and the wall.
4. Tighten all bolts. Pull the plate away from the wall to help tighten the bolts.
Use Top Cabinet template to prepare top cabinet.
1. Read the instructions on the TOP CABINET template, and then tape the
template underneath the overhead cabinet.
2. Drill the holes following the instructions on the TOP CABINET template.
•
Drill holes for the top support screws.
•
Drill a hole large enough for the power cord to fit through.
•
Drill a cutout large enough for the exhaust adaptor.
Adapt microwave blower for outside back exhaust.
1. Remove and save screw that holds blower motor to microwave.
2. Carefully pull out the blower unit. The wires will extend far enough toallow you to
adjust the blower unit.
c
a
3. Roll the blower unit 90°.
Before Rotation
a
b
c
b
After Rotation
a
b
a
Blower Motor
b
Back of Microwave
c
Blower Motor Screw
a
End A
b
End B
c
Before: Fan Blade Openings
Facing Forward
a
Fan Blade Openings
b
Back of Microwave
b
19