Step 4 - Align Wall-Mounting Plate - Haier HMV1652 Installation Instructions Manual

CABINETS WITH DECORATIVE TRIM
IMPORTANT: The microwave must be level. If a decorative cabinet trim is interfering
with the installation and leveling of the microwave oven, remove the decorative trim.
1. Use a level to make sure the cabinet bottom is level. If the cabinets have a front
overhang only, with no back or side frame, install the mounting plate down the
same distance as the front overhang depth. This will keep the microwave level.
2. Measure the inside depth of the front overhang.
3. Draw a horizontal line on the back wall an equal distance below the cabinet
bottom as the inside depth of the front overhang.
4. For this type of installation with front overhang only, align the mounting tabs
with this horizontal line, not touching the cabinet bottom.

STEP 4 - ALIGN WALL-MOUNTING PLATE

1. Draw a Vertical line on the wall at the center of the 30" (76.2 cm) wide space.
2. Draw a Horizontal line on the wall at the bottom of the Mounting Plate/Rear Wall
Template.
3. Drill 5⁄8" holes for toggle bolts in 2 locations (Hole A, Hole B) except if the location
of hole is same as that of stud, then drill a 3⁄16" hole for wood screw.
NOTE: A wood screw must be used in a stud location.
4. Set the mounting plate aside.
DO NOT MOUNT THE PLATE AT THIS TIME.
a
Horizontal Line
b
Area E
c
Center Line
d
Draw a Horizontal line on wall from
bottom of "Rear Wall Template".
e
Hole A
10
3/8" TO EDGE
12"
NOTE: IT IS VERY IMPORTANT TO
READ AND FOLLOW THE DIRECTIONS
IN THE INSTALLATION INSTRUCTIONS
BEFORE PROCEEDING WITH THIS
REAR WALL TEMPLATE.
This Rear Wall Template serves to position the bottom 4"
mounting plate and to locate the horizontal exhaust
outlet.
1. Use a level to check that the template is positioned
accurately.
2. Locate and mark at least one stud on the left or
right side of the centerline.
It is important to use at least one wood
screw mounted firmly in a stud to support the weight
of the microwave. Mark two additional, evenly spaced
locations for the supplied toggle bolts.
3. Drill holes in the marked locations. Where there is
a stud, drill a 3/16" hole for wood screws. For holes
that do not line up with a stud, drill 5/8" holes for
toggle bolts.
DO NOT INSTALL THE MOUNTING PLATE
AT THIS TIME.
4. Remove the template from the rear wall.
5. Review the Installation Instruction book for your
installation situation.
Darle vuelta a la hoja para consultar la
versión en Español.
Locate and mark holes to align with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE STUD ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY
SPACED TOGGLE BOLTS IN THE MOUNTING PLATE h
AREA.
i
a
b
c
Trim the rear wall template along the dotted line.
Locate and mark holes to align with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE STUD ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY
SPACED TOGGLE BOLTS IN THE MOUNTING PLATE
AREA.
g
d
f
e
f
Horizontal Line
g
Draw a Vertical Line on Wall from
Center of Top Cabinet
h
Centerline notches
i
Hole B